MAX7219LED8x8 is a C library for working with the MAX7219 display driver to control 8×8 LED matrix. It is intended to be used with the Tinusaur board but should also work with any other board based on Atmel ATtiny85 or similar microcontroller.
The MAX7219 is manufactured by Maxim Integrated is compact, serial input display driver that could interface microcontrollers to 64 individual LEDs such as 8×8 LED matrix. Only one external resistor is required to set the segment current for all LEDs.
To put that in simpler words – with the MAX7219 driver it is possible to control 8×8 LED matrix using just 2 wires serial interface – one for the sync clock and one for the data. There is another wire that could be used to enable/disable the communication with the chip. The maximum frequency for the serial interface is 10MHz.
The LED matrix 8×8 is connected almost diretcly to the MAX7219 driver – only few external components are required.
Working with MAX7219 is very simple – turning on and off individual LEDs is done by sending 2-bytes command to the driver containing the row and the byte which bits define which LED value to set.
There are also few other command that are needed during the initialization process.
The library supports short buffer – only 8 bytes in size – to keep the values before sending them to the driver.
MAX7219LED8x8 is written in plain C and does not require any additional libraries to function except those that come with the WinAVR SDK.
Using it is very simple …
MAX7219_init(); MAX7219_buffer_set(2, 3); // Set pixel MAX7219_buffer_clr(4, 5); // Clear pixel MAX7219_buffer_out(); // Output the buffer
Please continue to MAX7219LED8x8 page to see full source code the rest of the article.
The source code of the MAX7219LED8x8 library is available at https://bitbucket.org/tinusaur/max7219led8x8
MAX7219 specification and datasheet: